DustyFilm
02-02-2009, 11:49 AM
1980 Bronco 4x4 that’s ready to be a desert toy or made into a Class 3 racer. I got to the crossroads of toy and racer with this truck and just don’t have the time for either. The 351m has a fresh rebuild, only a couple passes down the alley to start the break-in. All new parts in the motor, balanced crank, arms and pistons (.030). Rebuilt heads and new kit in the Holley. All the Ford ignition parts are gone and replaced with a redundant MSD system, two of everything and on switches. MSD dual pick up distributor, 2 HVC boxes with rev limiters and two HVC coils all switched and can be selected on the fly. VDO gauges over the Art Carr shifter. Trans cooler on a switch. Full cage in the cab and ready for a bolt on rear bumper. Fuel cell bladder in the back holds fuel but the bottom is rusted. Has about a 4-inch lift on it right now with long arms on the front, this was the next step that I stopped on. All the 4x4 parts are in and working. This truck has the short transfer case that makes the rear drive shaft longer than the newer Broncos I’ve seen. I have a set of Sway-Away 14-inch coil overs for the front that go with the truck. The next step is yours. Also, I have a huge alum. Radiator included that was going to be installed after the motor break-in. Spare set of factory ford wheels. It is sitting on 33’s right now. Needs seats but have 2 Willans 6-point harnesses. I am rounding up all the other little parts and gathering them to go with the truck. Door panels are included; I was going to just skin the doors with alum. $4300 would make her all yours.
See more photos at - http://www.flickr.com/photos/brsphotos/
See more photos at - http://www.flickr.com/photos/brsphotos/