New rear bumper/trimmed fenders.

[Brokenbronco]

Howdy all, i got my new bumper installed, and did a little fender trimming. I'll be adding a spare tire mount in the near future.

http://offroadworld.tenmagazines.com/gallery/BknBronco/153956.jpg
http://offroadworld.tenmagazines.com/gallery/BknBronco/153957.jpg
http://offroadworld.tenmagazines.com/gallery/BknBronco/153954.jpg
http://offroadworld.tenmagazines.com/gallery/BknBronco/153955.jpg
http://offroadworld.tenmagazines.com/gallery/BknBronco/153961.jpg

[Blanco]

Looks good, gives you a nice departure angle.

Do you build it yourself?

[151FAB]

Really nice design, very clean looking.

That tailgate is a pain in the butt to deal with isn't it? The thing swings way low when open and prevents you from putting the bumper nice and close the the tailgate when its shut and you have to keep the bumper from hanging out too far because the gate gets lower the further out you go when its open.

[shaner17]

Sick! Im sending this design over to Jeff for some ideas on my bumper. I like that you can tow(light loads) because we are also using our bronco to launch our waverunners off the beach(no boat launch) in san felipe. Where are you putting the CA plates?

How much do you think you can tow with that hitch?

[BajaBronco13]

Nick,

Nice bumper. By the way, did you use a cut off wheel or a sawall to cut your rear panels? Those are nice clean lines.

CP

[BajaBronco13]

Did you have the same shop build your rear bumper that handled your front bumper or did you build them?

[Brokenbronco]

Really nice design, very clean looking.

That tailgate is a pain in the butt to deal with isn't it? The thing swings way low when open and prevents you from putting the bumper nice and close the the tailgate when its shut and you have to keep the bumper from hanging out too far because the gate gets lower the further out you go when its open.
The gate does touch slightly, but i'm not to worried about it.

Sick! Im sending this design over to Jeff for some ideas on my bumper. I like that you can tow(light loads) because we are also using our bronco to launch our waverunners off the beach(no boat launch) in san felipe. Where are you putting the CA plates?

How much do you think you can tow with that hitch?
Shane, there are tabs welded to the bumper for the licsense plate.
http://fordtruckworld.tenmagazines.com/gallery/itsnick/749167.jpg
The receiver is set back to be out of the way when in use, i had an extension made for towing.
http://fordtruckworld.tenmagazines.com/gallery/itsnick/749166.jpg
I have been assured that it will handle 500lbs on the tounge, and tow 3000lbs

Nick,

Nice bumper. By the way, did you use a cut off wheel or a sawall to cut your rear panels? Those are nice clean lines.

CP
Cut off wheel

Did you have the same shop build your rear bumper that handled your front bumper or did you build them?
I wish i could have built them! Another shop did the rear.

Thanks for all the replys!